Vonage phone hook up, hooking up vonage
That's what I did.
The modem is the device that enables you to connect to the internet. If all went well, you're ready to make calls!
This chain of events happens in reverse for audio coming from an analog source to a digital phone service. The scope of this How-To is going to cover just what's needed to connect VoIP, so hooking up computers to a router and things of that nature will not be explained in depth here.
The cable goes into the blue port that is marked with a globe. Reconnect your modem's power cord. Plug the blue Vonage Ethernet cable into the back of your modem.
You need to connect the ethernet cable from your TA to one of these ports on your router. The signal is then converted back to analog by the gateway so it can traverse the copper wires and end up coming out someone's analog phone.
That means two telephone numbers, two lines of service. Unpack your Vonage installation kit. A lot of these systems allow for up to 10 additional handsets.
You're going to want to connect an ethernet cable from the WAN or internet port on your TA typically colored blue. Plug the other end of the blue Ethernet cable into the Vonage phone adapter.
Regardless of how VoIP works, you just need to be able to make Vonage phone hook up work for you, right? Plug the Ethernet cable into the yellow port on the back of the Vonage phone adapter. The cable should be included with the materials you received from Vonage.
How to Hook Up Vonage.
Only remove the cable from the modem, not the computer. Routers usually have 3 or 4 additional ethernet ports for connecting computers. Depending on which terminal adapter you receive from Vonage, it may be a standalone unit that only serves the purpose of converting your voice signal between digital and analog, or it could be a multi-purpose unit that may also be a broadband router.
Disconnect the Ethernet cable from your modem. Plug in the phone line from your phone into the port labeled "Phone 1" on the back of your Vonage adapter.
Also known as a TA, a telephone adapter acts to convert the traditional analog voice signal your voice digital signal over the internet.
The kit contains everything you need to set up your service. Its important to realize that most terminal adapters especially from Vonage will only have 2 phone jacks on them - Phone 1 and Phone 2.
Check and see if you have a dial tone. Customers can use any corded or cordless phone to connect to Vonage's phone service. The easiest way around this would be a cordless phone system.
You should hear a steady dial tone when you pick up the phone. Ethernet and Internet may blink or stay steady at times but that's OK.
Other voice services are very similar. Check for Vonage phone hook up dial tone. With this method, you just plug the base station into your TA and you're good to go - the expanded handsets just need a power outlet.
Wait until you see "Phone Line 1"on the phone adapter's screen.
Ethernet cables are similar to phone cables but wider at the end. Doesn't matter which one. If you get a router model, you'll actually be able to hook a computer up to it or four, depending on your model - some also have wireless capability for connecting your computers to the internet.
In short, you end up sending a digital signal out when you make a call over the internet that will eventually be converted to analog. Items you will need. The Ethernet cable connects your modem to your computer.